JBL HTI6C - Manual (Page 4)

4
Phillips #2 screwdriver
Measuring tape Utility knife
Pencil
Carpenter’s level Awl
Tools Needed The HTI Series in-wall speakers
were designed to be easily
installed. However, if you are
unsure of your ability to prop-
erly install these loudspeakers,
please contact your dealer or
a qualified installer.
I N S T A L L A T I O N
Speakers and electronics
terminals have corresponding
(+) and (–) terminals. Most
manufacturers of speakers and
electronics, including JBL, use
red to denote the (+) terminal
and black for the (–) terminal.
It is important to connect both
speakers identically: (+) on the
speaker to (+) on the amplifier
and (–) on the speaker to (–)
on the amplifier. Wiring “out
of phase” results in thin sound,
weak bass and a poor stereo
image. With the advent of multi-
channel surround-sound
systems, connecting all of
the speakers in your system
with the correct polarity
remains equally important in
order to preserve the proper
ambience and directionality
of the program material.
Connection Tips
Wire Length Recommended Size
Up to 20 ft. 16 gauge
Up to 30 ft. 12 gauge
Greater than 30 ft. 10 gauge
Front or Rear Speaker Outputs
LEFT RIGHT
LEFT RIGHT
The wires for both speakers
should be the same length. If
one speaker is placed closer
to the amplifier than the other,
hide the excess wire behind
the wall.
S P E A K E R C O N N E C T I O N S