Iring, Ystem, Esting – Infinity QPS1 User Manual
Page 6: Peakers
Infinity QPS-1 – Owner’s Manual
◆
5
W
IRING
A
ND
P
OLARITY
...
I
MPORTANT
!
Figure 4. QPS-1 surround speakers feature
gold-plated terminals that can be
connected in several different ways;
e.g., banana plugs, spade terminals
(not shown) and direct wiring.
W
IRING
T
HE
S
YSTEM
After placing the speakers, you are ready to connect your system. First turn off all audio system
power. Use high-quality speaker wire to make the connections. Consult the owner’s manuals
(included with your amplifier, receiver or television) for connection and operation procedures.
QPS-1 speakers have gold-plated terminals that accept a variety of wire connectors (see Figure 4
below). Observe correct polarities when making speaker connections, as shown in Figure 5 (on
page 6).
Connect each
+
terminal on the back of the amplifier, receiver or television to the respective
+
(red) terminal on each speaker. Connect the
–
(black) terminals in the same way.
Do not reverse polarities (e.g.,
+
to
-
or
-
to
+
) when making connections.
T
ESTING
T
HE
S
PEAKERS
After placing and wiring the speakers, turn on audio system power. Follow the
instructions (packed with your A/V preamplifier or receiver) to calibrate the
Dolby
®
Pro Logic
®
or Dolby Digital channels. Most components include a built-in
test tone to help you balance the sound levels to all speakers in your system. During
calibration, verify that each QPS-1 reproduces the test tone. If not, check the wiring
connections and see the Troubleshooting chart (on page 7) for help.
Red =
+
Speaker Wire
CONNECTING SPEAKERS
USING BANANA PLUGS (NOT SUPPLIED)
CONNECTING SPEAKERS
DIRECTLY TO WIRES
Stripe =
–
No Stripe =
+
Black =
–
Red =
+
Black =
–
❶
Loosen Cap.
❷
Insert Bare
Wire End;
Tighten Cap.
Insert Bare End;
Tighten Terminal
❸
Insert Plug
Into Connector.
❶
Loosen Terminal.
Speaker Wire
No Stripe =
+
Stripe =
–
❷