Invacare 9000 User Manual

Page 22

PROCEDURE 7

FRONT RIGGING

This procedure includes the following:

Installing CLD Front Rigging Release Handle

WARNING

After ANY adjustments, repair or service and BE-
FORE use, make sure all attaching hardware is
tightened securely - otherwise injury or damage
may result.

INSTALLING CLD FRONT RIGGING
RELEASE HANDLE (FIGURE 1)

1. Remove the two (2) pan head screws, hex nut, riv

nut, bushing and spring from the EXISTING front
rigging release handle and retain for later use.

2. Position the bushing between the two (2) mounting

holes near the tab on the CLD release handle.

Riv Nut

Pan

Head

Screws

Bushing

Hex

Nut

Spring

Existing Release

Handle

Riv Nut

Pan

Head

Screws

Bushing

Hex Nut

Spring

CLD Release

Handle

Front Rigging

Front

Rigging

FIGURE 1 - INSTALLING CLD FRONT RIGGING RELEASE HANDLE

Tab

Mounting

Plate

3. Secure the bushing to the CLD release handle with

a pan head screw and hex nut. Tighten securely.

4. Position mounting hole "A" UNDER mounting hole

"B".

5. Position the hole in the spring UNDER mounting hole

"A" in the orientation shown in FIGURE 1.

NOTE: The bent portion of the spring should hook over
the mounting plate as indicated in FIGURE 1 and the
straight end of the spring should rest inside the CLD re-
lease handle and point away from the tab.

6. Secure the spring and CLD release handle to the

mounting plate with the remaining pan head screw
and riv nut. Tighten securely.

EXISTING

CLD

HOOK

SPRING HERE

G
G

Mounting

Hole "A"

Mounting Hole "B"

Bent Portion

of Spring

Straight

Portion

of Spring