Icom IC-R1500 - Manual (Page 22)

17
5
MEMORY OPERATION
VFO settings, including the set mode contents such as sub-
audible tone frequency, offset and scan skip information can
be programmed into a memory channel.
q Push [V/MHz•SCAN] to select VFO mode.
w Set the desired frequency using [DIAL].
➥ Set other data (e.g. subaudible tone frequency, scan
skip information, etc.) if required.
e Push [S.MW•MW] to enter select memory write mode.
• “ ! ” indicator and the memory channel number blink.
r Rotate [DIAL] to select the desired memory channel to be
programmed.
• Memory channels not yet programmed are blank.
t Push and hold [S.MW•MW] for 1 sec. to program.
• 3 beeps sound
• Memory channel number automatically increases when contin-
uing to push [S.MW•MW] after programming.
✔ CONVENIENT
Memory programming can be made quicker by copying mem-
ory information to different memory channels (p.19).
■
Programming a memory channel
[EXAMPLE]: Programming 145.800 MHz into memory channel 20 (blank channel).
Beep
“
Rotate Push for 1 sec. and continue to push
➠
Beep
“ Beep
Beep
Beep
“
“
“
“
“
Push Rotate for setting frequency, etc. Push .