Imperial DS1 - Manual (Page 14)

- 13 -
6. Other Option
This menu consists of 5 sub-menus as shown
below.
· System Setting
· Parental Lock
· Time Adjust
· Time Reservation
· Factory Default
6.1 System Setting
The System Setting menu allows you to set
items depending on your environment.
1. OSD Language : Lets you select the desired
language.
2. Audio Language: Select the desired audio
language to be in top priority under the
condition that this language is supported by
the channel.
3. LNB power: If your Imperial DS1 is
connected to the LNB, select YES. But if your
SRQ-5518-FTA is connected to another
receiver through Loop Through support, you
should check which receiver is connected
directly to the LNB. In case the other receiver
is directly connected to the LNB, then select
OFF.
4. Video output:If your SCART supports
RGB control, select RGB, Otherwire select
CVBS.
5. Display Info Bar : You can adjust the
displaying time inte rval for the info bar from 2
sec to 12 sec. Default value is 6 sec.
6. Start On Channel: If you press OK key, then
the channel list is displayed. You can select
one channel from the list. The selected
channel starts whenever you turn on SRQ-
5518-FTA.
7. UHF Standard: Select UHF type.
8. UHF Channel: Select your desired UHF
channel for satellite mode.
Note: In countries where UHF is not used,
options in List 6 and 7 will be deleted.