Invacare ICCG 6803A - Manual (Page 7)

Part No 1143214 7 ICCI Bed Rails and Accessories
FIGURE 9 Changing the Head Board Mounting Position
Changing the Mounting Position of the Mattress Keepers
NOTE: For this procedure, refer to FIGURE 10 on page 7.
NOTE: When using bed rails 6815A, 6816A, 6803A or IHRAILTS_DLX in conjunction with an 80-inch mattress, the mattress
keepers on the head end of the mattress deck MUST be adjusted.
1. Remove the two mounting screws that secure the mattress keeper to the head end of the mattress deck. See Detail
“A”.
2. Secure the mattress keeper to the head end of the mattress deck as shown in Detail “B” using two mounting screws
and locknuts. Securely tighten.
3. Repeat STEPS 1-2 to adjust the remaining mattress keeper on the head end of the mattress deck.
FIGURE 10 Changing the Mounting Position of the Mattress Keepers
Head Board Mounting Bracket
Bed Frame
Mounting Screws and Locknuts
DETAIL “A”
NOTE: Mounting position of head board mounting
bracket for use with 80-inch mattress - without side
rails
DETAIL “B”
NOTE: Mounting position of head board mounting bracket for
use with 80-inch mattress - using side rails 6815A, 6816A,
6803A, or IHRAILTS-DLX.
Mounting Screws and Locknuts
Bed Frame
Head Board Mounting Bracket
1-inch Gap
2-inch Gap
Mattress Keeper
Head End of
Mattress
Deck
Mounting Screws and Locknuts
2-inch Gap
DETAIL “B” DETAIL “A”
Mattress Keeper
Head End of
Mattress
Deck
Mounting Screws and Locknuts
1-inch Gap
NOTE: Mounting position of the mattress keeper for
use with 80-inch mattress - without side rails NOTE: Mounting position of the mattress keeper for use with
80-inch mattress - using side rails 6815A, 6816A, 6803A, or
IHRAILTS-DLX.