Installing/removing t-arms, Installing t-arms, Removing t-arms – Invacare Compass SPT PH904A User Manual

Page 42

SECTION 5—ARMS

2. Replace the existing clothing guard with the new clothing guard and securely tighten

with the existing hardware.

3. Repeat STEPS 1-2 for the opposite side if necessary.

Installing/Removing T-Arms

NOTE: For this procedure, refer to FIGURE 5.3.

Installing T-Arms

1. Position the T-Arm over the T-Arm socket on the wheelchair frame.

NOTE: Make sure the locking lever is towards the front of the wheelchair.

2. Slide T-Arm into T-Arm socket until the locking lever is in the slot in the T-Arm socket

and an audible “click” is heard.

3. Pull up on T-Arm to make sure T-Arm is locked in place.

NOTE: If the T-Arm does not slide in the T-Arm socket as desired, adjust the T-Arm socket. Refer
to Adjusting T-Arm Sockets on page 45.

4. Adjust the T-Arm for desired height, width and depth, if necessary. Refer to Adjusting

5. Repeat STEPS 1-4 for opposite side of wheelchair.

Removing T-Arms

1. Press the locking lever in and lift the

T-Arm straight up and out of the T-Arm
socket.

NOTE: If the T-Arm does not slide up and
down in the T-Arm socket as desired, adjust the
T-Arm socket. Refer to Adjusting T-Arm
Sockets on page 45.

2. Repeat STEP 1 for opposite side of the

wheelchair.

FIGURE 5.3 Installing/Removing T-Arms

T-Arm
Socket

Locking Lever

(towards the front of

the wheelchair)

T-Arm

Wheelchair

Frame

Slot

This manual is related to the following products: