Infinity TSS-CENTER4000 - Manual (Page 3)

3 TSS-CENTER4000
Tilting the Speaker
If needed, the enclosed stand allows you to tilt the speaker
across a wide range (i.e., up a maximum of 18˚ or down a
maximum of 7˚), as shown in Figure 3.
Important!
Do not exceed the tilt range. Doing so may cause the speaker to
fall out of its stand.
Figure 3.
Wall-Mounting the TSS-CENTER4000 Using the
Included Wall Bracket
The customer is responsible for proper selection and use of
mounting hardware, and for correctly and safely wall-mounting
the speakers.
Step One
Remove the wall bracket cover by removing the four wall bracket
screws on the ends as shown.
Step Two
Run the speaker wire behind the wall bracket and out the hole
in the center. After deciding where to place the center speaker,
attach the wall bracket (in a horizontal position) to the wall
using the appropriate screws and anchors.
Step Three
Run the speaker wires out through the hole in the center of
the wall bracket cover. Resecure in place with the four wall
bracket screws, as shown.
Mounting Screws and Anchors
Not Included
Wall Bracket
Center Hole
INFP1594Center-4000om 10/18/04 2:34 PM Page 3