iHome IPOD IH52 - Manual (Page 14)

Using The Remote Control Unit
Install/Replace the Remote Control Batteries
The remote control batteries are already installed at the factory.
When the remote control stops operating or its range seems
reduced, replace the batteries with new ones.
1. The battery door is located on the back end of the unit.
2. Press to release the battery door latch.
3. Insert 2 “CR2032” 3-volt lithium batteries. Make sure the
polarity (the + and – side of the battery) is correct.
4. Replace the battery holder back in the remote control.
NOTE: PLEASE DISCARD BATTERIES PROPERLY
CHANGING THE REMOTE CONTROL CODE
The iH52 has 4 DIP switches located in the backup battery compartment (see page 11) and in the remote control battery
compartment. If you experience interference from other remotes or have more than one iH52 operating at once, you may
need to change the DIP switch settings (DIP settings on remote and base unit must always match). To do so:
a) Open the battery compartment on both the remote control and the iH52.
b) Check that all DIP switch positions on unit and remote control match
c) Use fingernail or small object such as a paperclip tip to move ONE of the switches on the base unit to a different position.
Do the same on the remote, making sure to move the same switch to the same position so the switches on
each match.
d) Test performance. If interference is still an issue, adjust DIP switch settings again.
OPERATING THE REMOTE CONTROL
The Remote Control controls basic functions on the iH52 and certain iPod ® functions when the iPod ® is docked in the iH52.
For best results, aim remote control towards the receiver.
12
ᕡ Power On/Off Button: Turns iH52 ON or OFF
· Play/Pause Button : Plays track. In play mode, press to pause
» Select Down/Rew Button: Skip to previous or next track
when iPod is playing, or HOLD to scan current playing track
¿ Aux/iPod/Shuffle Button: Select Aux, iPod or Shuffle mode
´ Settings Button: Selects EQ and dimmer settings
² Display Button: Selects standard or extended display modes
¶ Mute Button: Toggles sound ON or OFF
º Volume + Button: Raises volume level
¾ Select Up/FF Button: Skip to previous or next track
when iPod is playing, or HOLD to scan current playing track.
µ Volume – Button: Lowers volume level
¸ Radio Button: Play radio, select AM or FM band
¹ Preset Button: Selects/sets up to six AM or FM station presets
Install Remote Control Battery
Battery
door
DIP switches
mute
radio
display presets
iPod/
aux
eq/
dimmer