Section 4- front riggings, Installing/removing front riggings, Installing – Invacare Lightweight User Manual

Page 31: Removing, Section 4—front riggings

SECTION 4—FRONT RIGGINGS

SECTION 4—FRONT RIGGINGS

ƽ WARNING

After any adjustments, repair or service and before use, make sure all attaching

hardware is tightened securely. Otherwise injury or damage may occur.

Installing/Removing Front Riggings

NOTE: For this procedure, refer to FIGURE 4.1.

Installing

1. Turn the front rigging assembly to the

side (open front rigging is
perpendicular to wheelchair).

2. Install the hinge plates on the front

rigging assembly onto the hinge pins
on the wheelchair frame.

3. Push the front rigging assembly

towards the inside of the wheelchair
until it locks into place.

NOTE: The footplate will be on the inside of the
wheelchair when locked in place.

4. Repeat this procedure for the other

front rigging assembly.

5. To release the front rigging, push the

front rigging release lever inward,
rotate front rigging outward.

FIGURE 4.1 Installing/Removing Front

Removing

1. Push the front rigging release lever inward

2. Rotate swingaway front rigging assembly outward.

3. Lift the swingaway front rigging assembly off the hinge pins.

Front Rigging

Release Lever

Front Rigging

Assembly

Footplate

Hinge
Plates

Hinge

Pins

NOTE: Swingaway footrest shown.