Insignia NS-F14TV - Manual (Page 18)

18
Insignia NS-F14TV 14" Flat Panel TV
www.insignia-products.com
Using your TV
Turning your TV on and off
To turn your TV on and off:
1 Plug the power cord into an electrical outlet.
2 Press the Power button on your remote control.
Selecting the TV signal type
To select the TV signal type:
• Press the DTV/ATV button. You can select digital TV (DTV) or
analog TV (ATV).
Changing TV channels
To change TV channels:
• Press the CH or CH button on your remote control or TV.
To enter channel numbers and date settings directly:
• Analog TV–To enter a two-digit channel number, press the two
numbers within two seconds of each other. For example, to
select channel 12, press 1 then press 2. The channel changes
after two seconds. If you enter a 0 before you enter the 1 and
2, the channel changes immediately.
• Digital TV–To enter a channel number, enter the main channel
number, press the • button, then, within four seconds, enter the
subchannel number. For example, to select channel 38-12,
press 3, 8, •, 1, then 2. If you press the • button after you press
2, the channel changes immediately.
Note
The power indicator turns off when your TV is active. The
power indicator turns red when the your TV is in Standby
mode. When your TV has a blue screen or is displaying a
screen saver, your TV goes into standby mode after five
minutes.