Intel 520T - Manual (Page 3)

1
Power
Reset
Status Temper ature RPS
Console
Blink Solid Activity Link Collision Disabled
LEDs Green Orange
Solid Off 100Mbps 10Mbps Full duple x Half duple x
LEDs Green Orange
Port Status
9600-8-N-1
Slot A
Slot B
Intel Express
520T Switch
10 11 12
8 7 6 5 4
9
1 2 3
10/100
Quick Start
Install the Express
520T Switch
Connect the Devices
Check the
Connections
3
1
2
Rack: Use the small
screws to attach the
brackets to the switch.
Shelf: Peel off the protective
backing and attach the rubber
feet to the switch.
• Remove the switch and parts from the box.
• Attach the enclosed brackets if you plan to
mount the switch in a 19-inch rack.
• Install the switch in a rack or on a shelf.
• Plug in the power cord.
• Check the port LEDs to confirm the link
status.
• A solid green LED indicates a valid link.
• A flashing green LED indicates a valid
link and network activity on the port.
• All ports are set to automatically detect
the speed and duplex mode of the device
connected to it.
• Connect servers and PCs to the switch
with a straight-through cable.
• Use a crossover cable to connect the
switch to a hub or another switch.
• Use only CAT 5 UTP to connect 100Mbps
devices. To connect 10Mbps devices use
CAT 3, 4, or 5 UTP.
Left (Green)
Solid = Link
Flashing = Activity
Right (Orange)
Solid = Disabled
Flashing = Collision
Switch Hub
Switch Switch
Switch PC/Server
straight-through
From To
crossover
English