Invacare JYMNI 9000 User Manual

Page 2

9000 Series and Jymni Anti-tippers

Part No. 1058751

INSTALLING ANTI-TIPPERS (FIGURE 1)

1. Remove plug button (not shown) from end

of rear frame tubing and install anti-rattles if

not already installed.

2. Press the release buttons IN and insert the

anti-tippers with the anti-tipper wheels

pointing toward the ground/floor into the

rear frame tubing until the bottom release

button locks in place.

3. Measure the distance between the bottom

of the anti-tipper wheels and the ground/

floor.

NOTE: A 1-1/2 to 2-inch clearance between the bottom of the anti-tipper wheels and the ground/floor MUST

be maintained at all times.
4. ADJUSTABLE ANTI-TIPPERS ONLY - If the distance between the bottom of anti-tipper

wheels and the ground/floor is not 1/1/2 to 2-inches, adjust anti-tippers. Refer to ADJUSTING

THE ANTI-TIPPERS in this instruction sheet.

1-1/2 to 2-inch Clearance

FIGURE 2 - ADJUSTING THE

ANTI-TIPPERS

Release Buttons

ADJUSTING ANTI-TIPPERS (FIGURE 2)

NOTE: This procedure is for adjustable anti-tip-

pers only.
1. Press the release buttons on the

wheeled portion of the anti-tipper and

slide it up or down to achieve the 1-1/2

to 2-inch clearance.

2. Check to make sure that the release

buttons are fully engaged in adjustment

holes.

FIGURE 1 - INSTALLING THE

ANTI-TIPPERS

Anti-Tipper

Release Buttons

Rear Frame Tubing

Anti-Tipper Wheels

Anti-Rattle