ICP DAS USA TDRS4050601 - Manual (Page 51)

Industrial Redundant Ring Switch – RS Series User Manual
TDRS4050601 p
mtime [time]
Description
This command enables you to setup the spanning tree bridge maximum age in
milliseconds(ms) . Max age is the maximum time a bridge waits without receiving
spanning tree configuration messages before attempting a reconfiguration.
To setup the maximum time manually, you are required to switch the SW1 Jumper 4
to “on” position (applying STP protocol), and SW2 to position „0‟ (if the SW2 position
is not on „0‟, a preset value will be applied according to its corresponding position,
please refer to Appendix G, Table
– 15. If SW1 jumper 4 is not on “on” position; that
is, not applying STP protocol, mtime is not applicable)
Parameters
Parameter Description
time Provides the time interval(ms) that you want to set
up as the maximum time
Example:
htime [time]
Description
This command enables you to set the spanning tree bridge hello time in millisecond
(ms). Hello time is the interval between transmission of spanning tree configuration
messages. All bridges send configuration messages during reconfiguration to select
the designated root bridge (in this case, the switch port).
To setup the hello time manually, you are required to switch the SW1 Jumper 4 to
“on” position (applying STP protocol), and SW2 to position „0‟ (if the SW2 position is
not on „0‟, a preset value will be applied according to its corresponding position,
please refer to Appendix G, Table
– 15. If SW1 jumper 4 is not on “on” position; that
is, not applying STP protocol, htime is not applicable)
Parameters
Parameter Description
time Provides the time interval(ms) that you want to set
up as the hello time
Example: