Image IMBE39400 - Manual (Page 9)

9
10
10. Locate a Cable (25) and notice that there is a ball
on one end of the Cable and a metal sleeve on the
other end.
Route the metal-sleeve end of the Cable (25) up
under the lat bar rest on the Weight Guide Frame
(14), down through the indicated hole, back up
through the next hole, and then down through the
hole between the Weight Guides (9) as shown.
11. Insert the end of the Cable (25) into the hole in the
center of the Weight Carriage (15). Attach the Cable
using a 3/8” x 2 1/2” Bolt (35), two 3/8” Washers
(37), two 3/4” Spacers (38), and a 3/8” Nylon Lock
Jamnut (29).
12 Lift the Cable (25) in the location shown. Attach two
Pulleys (24) inside the bracket on the Weight Guide
Frame (14) using two 3/8” x 2” Bolts (32) and two
3/8” Nylon Lock Jamnuts (29).
25
11
15
12
29
32
24
25
14
35
37
37
29
9
14
Lat Bar
Rest
25
38
38
13
25
14
34
29
37
38
24
13. Lift the Cable (25) in the location shown. Attach two
Pulleys (24) inside the Weight Guide Frame (14)
using two 3/8” x 3” Bolts (34), four 3/8” Washers
(37), four 3/4” Spacers (38), and two 3/8” Nylon
Lock Jamnuts (29).
37
37
37
38
38
38