Image IMBE39400 - Manual (Page 8)

8
8. Insert the two Weight Guides (9) into the Weight
Guide Base (4). Attach the Weight Guides using
two 5/16” x 4” Bolts (86), four 5/16” Washers (36),
and two 5/16” Nylon Locknuts (30).
Slide the two Weight Bumpers (18) and the Weight
Carriage (15) over the Weight Guides (9).
Be sure
the Weight Bumpers are on the bottom.
7. Press the two 2” Round Inner Caps (42) into the
weight tubes on the Weight Carriage (15).
Make sure the Weight Carriage is turned so the
weight tubes are near the top, as shown. Attach
the lower Carriage Bushing (16) to the Weight
Carriage (15) using a 3/8” x 2 1/2” Bolt (35), two
3/8” Washers (37), the 2” Spacer (39), and a 3/8”
Nylon Lock Jamnut (29).
42
42
15
Weight Tube
35 37
39
37
16
29
6. Press a 2 1/2” Square Inner Cap (28) into the Left
Frame (12). Attach the Left Frame to the left
Uprights (7, 8) using four 3/8” x 3 1/2” Bolts (31)
and four 3/8” Nylon Lock Jamnuts (29).
Do not
tighten the Nylon Lock Jamnuts yet.
Assemble the Right Frame (10) to the right Uprights
(7, 8) in the same manner.
Attach the Center Frame (11) to the Left Frame (12)
and the Right Frame (10) using four 3/8” x 3 1/2”
Bolts (31) and four 3/8” Nylon Lock Jamnuts (29).
Tighten all Nylon Lock Jamnuts used in steps
1–6.
29
28
29
31
31
31
31
10
11
12
29
29
6
7
8
7
8
8
7
15
18
4
36
30
9
86
9
9. Press a 2 1/2” Square Inner Cap (28) into the end
of the Weight Guide Frame (14). Wipe the lat bar
rests on the Weight Guide Frame with lubricant.
Slide the Lat Bar Rest Sleeves (84) onto the lat bar
rests.
Hold the Weight Guide Frame (14) on top of the
Center Frame (11) and the Weight Guides (9).
Attach the Weight Guides to the Weight Guide
Frame using two 5/16” x 2” Bolts (33), four 5/16”
Washers (36), and two 5/16” Nylon Locknuts (30).
Attach the Weight Guide Frame (14) to the Center
Frame (11) using two 3/8” x 3 1/2” Bolts (31), two
3/8” Washers (37), and two 3/8” Nylon Lock
Jamnuts (29).
31
37
84
11
14
Lat Bar
Rest
29
9
33
36
28
36 30