beautypg.com

Assembly – Image IMTL14901 User Manual

Page 5

background image

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. A rubber mallet may be needed for
assembly.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.

1. With the help of a second person, carefully raise the

Uprights (65) until the treadmill is in the position shown.

2. Press the Lock Knob Sleeve (68) into the left Upright

(65). If necessary, use a rubber mallet to tap the Lock
Knob Sleeve into the Upright.

Remove the Lock Knob (67) from the Lock Pin (72).
Make sure the Lock Pin Collar (70) and the Spring (69)
are on the Lock Pin as shown. (Note: If there are two
Lock Pin Collars, place one on each side of the Spring.)
Insert the Lock Pin into the Lock Knob Sleeve (68) and
the left Upright (65). Tighten the Lock Knob onto the Lock
Pin.

3. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a

secure place. The allen wrench is used to adjust the walking belt (see pages 25 and 26). To protect the floor
or carpet from damage, place a mat under the treadmill.

65

1

72

70

69

67

68

65

2

5