Image IMTL14901 User Manual

Page 18

When only three seconds remain in the first period
of the program, both the Current Period column
and the column to the right will flash, a series of
tones will sound, and all speed settings will move
one column to the left. The speed setting for the
second period will then be shown in the flashing
Current Period column and the treadmill will auto-
matically adjust to the second speed and incline
settings that you programmed previously.

The program will continue until the speed setting
for the last period is shown in the Current Period
column and the Time/Segment Time display
counts down to zero. The walking belt will then
slow to a stop.

Note: If the program is too easy or too difficult, the
speed or incline setting for the current period can be
adjusted with the Speed or Incline buttons.
Adjustments will not be stored in memory. To repro-
gram the speed or incline setting for the current pe-
riod, press the Record button. The custom program
indicator will begin to flash. Speed and incline set-
tings can be programmed only when the indica-
tor is flashing. Adjust the speed or incline setting for
the current period with the Speed or Incline buttons.
After the period is completed, press the Record but-
ton again. The new setting will be stored in memory.

To stop the program temporarily, press the Stop
button. All displays will pause and the Time/
Segment Time display will begin to flash. To
restart the program, press the Start button. To end
the program, press the Stop button, remove the
key, and then reinsert the key.

Follow your progress with the five displays.

Refer to step 6 on page 11.

Remove the key from the console.

When the program has ended, make sure that
the incline of the treadmill is at 0%. Next, re-
move the key from the console. Keep the key in a
secure place. Note: If the displays and indica-
tors on the console remain lit after the key is
removed, the console is in the “demo” mode.
Refer to page 23 and turn off the demo mode.

Next, move the on/off switch near the power cord
to the off position.

HOW TO CONNECT THE TREADMILL TO
YOUR CD PLAYER, VCR, OR COMPUTER

To use iFIT.com CD’s, the treadmill must be con-
nected to your portable CD player, portable stereo,
home stereo, or computer with CD player. See pages
18 to 20 for connecting instructions. To use iFIT.com
videocassettes, the treadmill must be connected to
your VCR. See page 20 for connecting instructions. To
use iFIT.com programs directly from our internet
site, the treadmill must be connected to your home
computer. See page 20 for connecting instructions.

HOW TO CONNECT YOUR PORTABLE CD PLAYER

Note: If your CD player has separate LINE OUT and
PHONES jacks, see instruction A below. If your CD
player has only one jack, see instruction B.

A. Plug one end of the audio cable into the jack on the

front of the treadmill near the power cord. Plug the
other end of the cable into the LINE OUT jack on
your CD player. Plug your headphones into the
PHONES jack.

B. Plug one end of the audio cable into the jack on the

front of the treadmill near the power cord. Plug the
other end of the cable into a 3.5mm Y-adapter
(available at electronics stores). Plug the Y-adapter
into the PHONES jack on your CD player. Plug your
headphones into the other side of the Y-adapter.

LINE OUT

PHONES LINE OUT

PHONES

Audio

Cable

Head-

phones

PHONES

Audio

Cable

3.5mm

Y-adapter

Headphones