Integra DTR-6.4/5.4 - Manual (Page 65)

65
Using remote controller
-- / ---
1 2 3
4 5 6
+10 0
7 8 9
Audio Sel Muting
Angle Subtitle
TV / VCR
Random Audio Adjust
Enter
Search
Input Selector
Dimmer Zone 2 Display
SURR THX
Stereo Direct
All ST
VOL C H
Disc
Pure A
Rec
DSP DSP Re-EQ
Level
A M
V 1
DVD
V 3 V 4 V 5
C D
V 2
P H
TAP TUN
RC-534M
Muting
VOL
On Standby
SAT/MD Mode
Enter
Numeric keys
MD
operation
buttons
The connector of the Onkyo MD recorder must be connected to
the DTR-6.4/5.4 (see page 28).
1. Press the SAT/MD Mode button.
The SAT/MD Mode button lights.
2. Press the desired operation button.
The buttons shaded in the figure to the left are the operation
buttons that can be used to control an Onkyo MD recorder.
Operation buttons:
On: Turns on and off MD player (same as Standby button on the
remote controller)
: Track down
: Track up
: Play
: Stop
: Skip backward
: Skip forward
Rec
●: Record
: Pause
: Eject
1 to 9, 0, --/---: Numeric keys
ENTER: Enters the settings
You may also use the following buttons:
VOL
: Adjusts volume at DTR-6.4/5.4
Muting: Activates muting function at DTR-6.4/5.4
Note:
The SAT/MD button is used for operating satellite tuners and
Onkyo MD recorders. Be aware that if you enter the preset code for
a satellite tuner as shown on page 66, then this button cannot be
used to operate Onkyo MD recorders.
If this is the case, to operate an Onkyo MD recorder, you must first
erase the satellite tuner code by following the directions given in
“Erasing all the commands programmed under a Mode button” on
page 71.
Controlling an Onkyo MD recorder