Insignia NS-R5101 - Manual (Page 28)

28
Insignia NS-R5101 5.1 Surround Sound A/V Receiver
www.insignia-products.com
2 Press the TUNING / buttons repeatedly
until the right frequency has been reached.
Auto presetting
The Auto Presetting function automatically
searches for FM stations only and stores them in
the memory.
To auto preset a radio station:
1 While listening to a radio station, press and
hold the MEMORY/ENTER button for more
than two seconds.
The AUTO MEM flickers and the receiver
starts auto presetting.
Manual presetting
To manually preset a radio station:
1 Tune to the station with auto or manual
tuning.
2 Press the MEMORY/ENTER button. MEM
flickers for several seconds.
3 Select a preset number between 1 and 30,
then press the MEMORY/ENTER button
again.
4 Repeat this procedure to memorize
additional stations.
Tuning to preset stations
To tune to a preset station:
1 Select the tuner as the input source.
2 Press the PRESET / buttons on the
receiver.
-OR-
Enter the preset number using the numeric
keypad.
Scanning preset stations in sequence
To scan preset stations:
1 Select the tuner as the input source.
2 Press the PRESETS button on the remote
control.
The receiver starts scanning the stations in
the preset sequence. Each station is
sampled for five seconds.
3 Press the PRESETS button again to stop
scanning.
Recording
Recording on audio (cassette) tape
To record on tape:
1 Select the recording input source (this cannot
be TAPE).
2 Start recording on the tape recorder.
3 Start play on your input device.
Notes
• Up to 30 FM stations can be stored.
• Weak FM stations cannot be stored. To store
weak stations or AM stations, perform “Manual
presetting” on page 28 along with using
“Manual tuning” on page 27.
Notes
• When using the numeric keypad on the remote
control, press the number you want. If your
number is greater than nine, enter the first digit,
then enter the second digit within two
seconds.The station has been stored in
memory.
• When using the numeric keypad, the station is
stored automatically without pressing the
MEMORY/ENTER button.
• A stored frequency is erased from memory by
storing another frequency in its place.
• If MEM goes off, start again from step 2.
TUNING Note
When using the numeric keypad on the remote
control, press the number you want. If your
number is greater than nine, enter the first digit,
then enter the second digit within two seconds.
Notes
• Analog signals from the EXTERNAL INs as
well as the digital signals from the coaxial or
optical digital input can be heard but cannot be
recorded.
• The volume and tone (bass and treble) settings
have no effect on the recording signals.
OR