Invacare MicroAIR MA50 User Manual
Page 27
4 OPERATION
27
4.9
Transferring Patient From/To a Wheelchair
1.
Engage the wheel locks of the bed. Refer to the owner’s manual provided with the bed.
2.
Engage the wheel locks of the wheelchair, if applicable. Refer to the owner’s manual provided with the wheelchair.
3.
Press the Max Inflate or Mode button to achieve maximum mattress pressure.
4.
Raise or lower the bed to match the wheelchair height. Refer to the owner’s manual provided with the bed.
5.
When the mattress has reached maximum firmness, perform one of the following:
•
Bed to Wheelchair Transfer - Slide the patient onto the wheelchair.
•
Wheelchair to Bed Transfer - Slide the patient onto the bed.
4.10 Preparing for CPR Procedure
1.
Press and hold the tabs on hose connector while pulling the hose from the control unit.
2.
Disconnect the RED CPR connector located on the side of the mattress.
ƽ
WARNING
ALWAYS engage the wheel locks of the bed and the wheel locks of the wheelchair before transferring the patient between
the bed and the wheelchair.
For this procedure, refer to FIGURE 6 on page 28.