iHome iH11 - Manual (Page 7)

Install/Replace the Remote Control Battery
The remote control battery is already installed at the factory. When the
remote control stops operating or its range seems reduced, it is time
to replace the battery with a new one.
1. The battery door is located on the back end of the remote control.
2. Pull the battery door to release the battery door latch and take out
the battery.
3. Insert a CR2032 battery, checking that the + and – sides of the
battery match the drawing inside the battery compartment.
4. Replace the battery door.
Note: Make sure you dispose of batteries properly (see your local regulations).
The Remote Control controls basic functions on the iH11 and certain iPod functions when the iPod is docked in the iH11.
For best results, aim remote control towards the remote sensor on the left side of the unit.
To check for iPod compatibility
iH11 is an advanced system and supports most updated iPod features. To ensure your iPod works properly with the iH11,
please update your iPod firmware with the latest version, available through iTunes.
Installing Remote Battery

 

 Power Off /Alarm Reset Button
 Snooze/Dimmer Button
Volume - Button 
 Reverse Button
 Forward Button
 Volume + Button
 Mute Button
 iPod Play/Pause Button
Sleep Button 
4
Using The Optional Remote Control Unit