beautypg.com

Alarm operation – iHome iH11 User Manual

Page 10

background image

The iH11 Home System for iPod features “Sure Alarm”. If a power failure occurs or the AC adaptor is accidentally
disconnected, the unit will change to buzzer alarm to wake you up (provided you have installed backup battery).
This unit also features Gentle Waking, which gradually increases the volume of whatever alarm you set.
NOTE: TO WAKE TO iPod, YOUR iPod MUST BE PROPERLY DOCKED AND OFF (NOT IN PLAY MODE) OR NO
ALARM WILL SOUND. You CANNOT wake to Line in audio devices.

Setting the Alarm Time

1. Press and hold the  Alarm Set Button for 2 seconds until the display flashes. Press the  Hour Set Button until the

desired alarm hour is displayed. Next, press the  Sleep/Minute Set Button to set the desired alarm minute.

Remember to set the correct AM or PM if you are using 12 hour clock format.

2. Press the  Alarm Set Button again to exit the setting mode. You should hear 2 beeps indicating the alarm is set.

Note: Once you set the alarm time, the alarm will be automatically armed, indicated by the Alarm Icon. To disarm the alarm,
press the  Alarm Set Button. The Alarm Icon will disappear and the alarm will not sound at the set time.

Note: Make sure to adjust volume level for comfortable wake up volume
4. When the alarm is sounding, the Alarm Icon will flash.

• To snooze during the alarm, press the  Snooze/Dimmer Button. The alarm will be silenced for 9 minutes, then come

on again.

• To turn the alarm off, press the  Alarm Reset/Power Off Button. The alarm will come on again the next day at the

same time.

5. If the alarm is not turned off after it sounds, it will play for approximately one hour then turn off automatically. This cycle

will repeat every 24 hours unless the controls are changed.

Note: Please make sure your iPod has enough songs to play for one hour, otherwise please set the iPod repeat mode to ON.
Note: If there is no iPod present or there is no music detected on the iPod at alarm time, the iH11 will automatically switch to
buzzer alarm.

7

Alarm Operation