IBM 40/80 GB DLT - Manual (Page 33)

Resetting the drive
The reset procedure rewinds the tape and clears the buffer of previous tape drive
commands and data. To reset the tape drive, press the Unload button, or turn the
computer off and back on again.
If you reset the tape drive while a cartridge is loaded, the tape rewinds to the
beginning. The reset might take as long as two minutes if the tape is positioned near
the end. After the drive has been reset, tape operation starts from the beginning of the
data cartridge. After resetting the drive, restart your backup tape software.
Packing the drive for shipping
If you are shipping the tape drive to another location or returning it for repair, pack
the tape drive in its original shipping container and packing materials.
Attention: To avoid damaging the tape drive, use the original shipping materials
when you ship it. Your proof of purchase might be required to receive warranty
service. If you are returning the tape drive for service, remove and keep all
cartridges, cables, and terminators.
Thank you for purchasing OPTIONS by IBM  . Please take a few moments to register
your product and provide us with information that will help IBM to better serve you in
the future. Your feedback is valuable to us in developing products and services that
are important to you, as well as in developing better ways to communicate with you.
Register your option on the IBM Web site at:
http://www.ibm.com/pc/register
IBM will send you information and updates on your registered product unless you
indicate on the Web site questionnaire that you do not want to receive further
information.
Part 1: Installation, use, and maintenance guide 1-27