Invacare 6210 User Manual

Page 7

FIGURE 3 - REPLACING THE WHEELS/REPLACING THE ONE-WAY

WHEELS WITH TWO-WAY WHEELS

CONVERTING THE REVERSE POSTURAL (PULLING)
WALKER TO A FOWARD (PUSHING) WALKER
(FIGURE 4)

NOTE: Refer to INSTALLATION WARNINGS in the SAFETY SUMMARY in this
instruction sheet.

NOTE: Walker is shipped in the reverse postural (pulling) walker configuration.

NOTE: Right, Left, Front, and Rear sides are determined from using the walker in
the reverse postural (pulling) configuration.

NOTE: Two (2) of the four (4) wheels provided with the walker are "one-way" wheels,
which roll in only one (1) direction. This allows the walker to be used as either a
reverse postural (pulling) walker, or a forward (pushing) walker.

NOTE: On a reverse postural (pulling) walker both of the one-way wheels are
mounted to the rear frame tubes. On a forward (pushing) walker both one-way
wheels are mounted to the front frame tubes.

NOTE: Take note of the location and orientation of the one-way wheels before removal.

NOTE: When installing the one-way wheels into the front frame tubes, their position
is reversed in order to change the direction of rotation.

Set Screw

Spacer

Bushing

(Two-Way Wheel Only)

Washer

Mounting

Screw

Wheel

Wheel Insert

Tube Frame

Locknut

Washer

Mounting

Screw

This manual is related to the following products:

6211