Ikelite SLR-DC Housing D700 - Manual (Page 7)

7
Attaching Camera to Camera Tray
Remove the back from the housing. The mounting tray for the camera is
secured to the housing back. Position the camera and lens on the
camera tray, and then secure it
with the mounting bolt which
threads into the camera’s
tripod socket.
Use a flathead screwdriver
(recommended) or coin to
tighten the mounting bolt so
the camera bottom is flush
against the tray.
The Leveling Screw is factory
preset and does not need to
be adjusted.
Setting the Conversion Circuitry Strobe ID Switch
Inside the housing back on the black panel,
the conversion circuitry has a switch for setting
the DS Substrobe ID. Set the conversion
circuitry strobe ID switch located to the Model
of DS Substrobe being used.
When using dual strobes of different models
such as a DS51 and a DS161, set the ID
switch to DS51 or the smaller strobe.
DS DS
125 50
51
160
161
ikelite
Set DS Substrobes
to TTL Mode
200
Nikon
D700
FX
Mounting
Bolt
Camera
Tray Leveling
Screw