Invacare 1335 User Manual

Page 2

3. Determine an acceptable mounting location for the non-folding device.
NOTE: The location depends on the wheelchair model. The non-folding device can be mounted to
7/8-inch (using plastic insert guide) or 1-inch diameter tubing. For any wheelchair model, it can
be installed on to at least one of the following locations:

A. Rear upright tubes (Detail “A”)
B. Rear step tubes (Detail “A”)
C. Upper frame tubing (Detail “B”)

NOTE: When mounting on the upper frame tubing under the seat, the non-folding device MUST
be mounted just in front of the rear seat guides.
4. Unfold the wheelchair. Refer to owner’s manual supplied with the wheelchair.
5. Position one clamp of the non-folding device in the pre-determined position from STEP

3 as shown in FIGURE 1. If you are mounting this device on 7/8-inch tube, put the plastic
insert guides around the 7/8-inch tube under the clamps.

6. Squeeze the two halves of the clamp together.
7. Insert the hex head bolt through the clamp.
8. Install the locknut onto the hex head bolt.
9. Extend the non-folding device to position the remaining clamp on the opposite side of

the wheelchair in the position determined in STEP 3.

10. Repeat STEPS 5-7 to secure the remaining clamp.
NOTE: Ensure clamps at both ends sit flush on the wheelchair frame and DO NOT interfere with
wheelchair function.
11. Securely tighten the locknuts on the hex head bolts in the clamps at both ends of the

non-folding device.

12. Securely tighten the locknut on the lug bolt in the adjustment clamp.

FIGURE 1 Installing the Non-Folding Device

Locknuts

Rear Upright

Tube

Clamp

Adjustment

Clamp

Hex Head Bolt

Rear Step

Tube

DETAIL “A”

DETAIL “B”

Adjustment

Clamp

Rear Seat

Guides

Hex

Head Bolt

Locknuts

Upper Frame

Tubing

Clamp

Lug

Bolt

Invacare Corporation

www.invacare.com

USA

One Invacare Way

Elyria, Ohio USA

44036-2125

800-333-6900

Canada

570 Matheson Blvd E Unit 8

Mississauga Ontario

L4Z 4G4 Canada

800-668-5324

Invacare, Yes, you can. and The Medallion

Design are registered trademarks of

Invacare Corporation.

Part No. 00083x072

Rev F - 05/3/06