Icom IC-F4063T/S - Manual (Page 27)

23
7
BATTERY CASE
7
6
■
Optional battery case (BP-240)
When using the optional battery case attached to the trans-
ceiver, install 6
× AAA (LR03) size alkaline batteries as illus-
trated at right.
q Unhook the battery cover release hook (
q
), and open the
cover in the direction of the arrow ( w ). (Fig.1)
w Then, install 6 × AAA (LR03) size alkaline batteries. (Fig.2)
• Install the alkaline batteries only.
• Be sure to observe the correct polarity.
• Do not pin the ribbon under the batteries.
e Fit the cover in the direction of the arrow (
e
), then close
( r ). And hook the battery cover release hook until it
makes a ‘click’ sound ( t ). (Fig.3)
CAUTION:
• When installing batteries, make sure they are all the same
brand, type and capacity. Also, do not mix new and old
batteries together.
• Keep battery contacts clean. It’s a good idea to clean bat-
tery terminals once a week.
• Never incinerate used battery cells since internal battery
gas may cause them to rupture.
• Never expose a detached battery case to water. If the bat-
tery case gets wet, be sure to wipe it dry before using it.
NOTE: When the optional battery case is attached, the
battery type must be selected to “DRY BATT” when turn-
ing the transceiver ON. ((
☞ p. 10))
q
BP-240
w Fig.1
Fig.2
Fig.3
e
r
t