Icom IC-F4063T/S - Manual (Page 13)

9
2
PANEL DESCRIPTION
2
CALL KEYS “
C CA AL LL L
” “
C CA AL LA A
” “
C CA AL LB B
”
Push to transmit a 2-tone.
• Call transmission is necessary before you call another station
depending on your signaling system.
• [Call A] and/or [Call B] may be available when your system employs
selective ‘Individual/Group’ calls. Ask your dealer which call is
assigned to each key.
EMERGENCY KEY “
E EM MR R
”
Push and hold for a specified period to transmit an emer-
gency call.
• If you want to cancel the emergency call, push (or push and hold)
the key again before transmitting the call.
• The emergency call is transmitted one time only or repeatedly until
receiving a control code depending on the pre-setting.
SURVEILLANCE KEY “
S SU UR RV V
”
Push to turn the surveillance function ON or OFF.
When this function is turned ON, the beep is not emitted and
the LCD backlight does not light when a signal is received or
a key is pushed, etc.
TX CODE CHANNEL SELECT KEY “
T TX XC C
”
➥
Push to enter the ID code channel selection mode directly.
Then set the desired channel using [CH Up]/[CH Down].
((
☞
p. 15))
TX CODE CHANNEL UP/DOWN KEYS “ T TX XC CU U ” “ T TX XC CD D ”
Push to select a TX code channel directly.
SCRAMBLER FUNCTION “
S SC CR R
”
Push to toggle the voice scrambler function ON and OFF.
COMPANDER KEY “
C CO OM MP P
”
Push to toggle the compander function ON and OFF.
The compander function reduces noise components from the
transmitting audio to provide clear communication.
PHONE KEY “
P PH HN N
”
Push to connect or disconnect the telephone network con-
nection during LTR operation.
USER SET MODE KEY “ S SE ET T ”
➥ Push and hold to enter user set mode.
• During user set mode, push this key to select an item, and
change the value or condition using push [CH Up]/[CH Down].
➥
Push and hold this key again to exit user set mode.
User set mode is also available via the ‘Power ON function.’
Refer to ((
☞ p. 16)) also.
OPT OUT KEYS “ O OP P1 1 ” “ O OP P2 2 ” “ O OP P3 3 ”
Push to control the output signal level of the optional ports in
the optional unit connector.
OPT MOMENTARY KEYS “
O O1 1M M
” “
O O2 2M M
” “
O O3 3M M
”
Push and hold to control the output signal level of the option-
al ports in the optional unit connector.