Icom IC-F4063T/S - Manual (Page 14)

■
Turning power ON
Prior to using the transceiver for the first time, the battery
pack must be fully charged for optimum life and operation.
((
☞ p. 20))
q Rotate [VOL] to turn the power ON.
w If the transceiver is programmed for a start up password,
input the digit codes as directed by your dealer.
• 10-keypad can be used for password input depending on ver-
sion:
• The keys in the table below can be used for password input:
• The transceiver detects numbers in the same block as identical.
Therefore “01234” and “56789” are the same.
e When the “PASSWORD” indication does not clear after
inputting 4 digits, the input code number may be incorrect.
Turn the power off and start over in this case.
D Battery type selection
The battery type must be selected according to the attaching
battery type when tuning the transceiver ON..
➥ While pushing and holding [Emer] and [PTT], rotate [VOL]
to toggle the attaching battery type.
• After the display appears, release [Emer] and [PTT].
• “DRY BATT” is displayed for about 3 sec. then “Lo” appears
when the battery case operation is selected.
• “LI-ION” is displayed for about 3 sec. when the Lithium-ion bat-
tery operation is selected.
• This operation may not be available depending on the pre-setting.
Ask your dealer for details. KEY
NUMBER
0
5
4
9
3
8
2
7
1
6
(Side3)
10
3
BASIC OPERATION