Integra DTR-6.2 - Manual (Page 33)

33
Using listening mode
Changing the listening mode
To change the listening mode during playback, press the listening
mode buttons on the remote controller.
You can also set the listening mode using the jog dial on the DTR-
6.2. Push the jog dial repeatedly to cycle the listening mode from
Direct
→Stereo→Surround→All Ch Stereo→Direct. Turn the jog
dial to change the listening mode in the same manner as DSP / on
the remote controller.
DIRECT: Changes the listening mode directly to the Direct
listening mode. If pressed, the listening mode for the selected input
source set in the Listening Mode Preset sub-menu is also changed to
the Direct listening mode.
STEREO: Changes the listening mode directly to the Stereo
listening mode. If pressed, the listening mode for the selected input
source set in the Listening Mode Preset sub-menu is also changed to
the Stereo listening mode.
SURR (Surround): Changes the listening mode to the surround
mode for the current input signal (e.g., Dolby Pro Logic II, Dolby
Digital, or DTS). If pressed, the listening mode for the selected input
source set in the Listening Mode Preset sub-menu is also changed to
the Surround listening mode.
For Dolby Pro Logic II, this button also changes the mode between
Dolby Pro Logic II Movie and Dolby Pro Logic II Music.
A.ST(All Channel Stereo): Changes the listening mode directly to
the Stereo listening mode. If pressed, the listening mode for the
selected input source set in the Listening Mode Preset sub-menu is
also changed to the All Channel Stereo listening mode.
DSP / : Changes the listening mode as shown below.
Direct
↔ Stereo ↔ Surround ↔ Orchestra ↔ Unplugged ↔
Studio-Mix ↔ TV Logic ↔ All Ch Stereo ↔ Direct.
If pressed, the listening mode for the selected input source set in the
Listening Mode Preset sub-menu is also changed.
Note:
If you want to switch between Dolby Pro Logic II Movie and Dolby
Pro Logic II Music at the DTR-6.2, press the jog dial and select
“Surround” for the listening mode.
Push To Enter
DSP / Mode ADJ
DTR-6.2 Remote controller
Using Cinema Re-Equalization
Depending on the listening mode, you can either turn Re-EQ on or
off. Re-EQ (re-equalization) takes the edginess or “brightness” out
of your home cinema sound to compensate for the fact that sound
mixed for theaters may sound too bright when played back through
speakers in the home environment.
Remote cotroller only
On: Select to turn on the re-equalization filter.
Off: Select to turn off the re-equalization filter.
Note:
The Re-EQ function is effective on the Dolby Pro Logic II Movie
and Dolby Digital modes.
MUTING
HOME THEATER CONTROLLER RC-441M
Standby/On
Standby
Power
On O f f
Phones Video 1 Video 3 DVD Video 2 Video 4 Audio Selector Bass Treble
Master Volume
Smart Scan Navigator
Rec Out Zone 2 Zone 2 Level CH Level
Dimmer Display Tuning FM Mode Preset Memory Preset
VCR 1 VCR 2
Tape FM AM Phono CD
Push To Enter
DSP/ Mode ADJ Setup
Return
Re-EQ
Listening
mode
buttons
Jog dial