Integra DTR-6.2 - Manual (Page 27)

27
Listening to Radio Broadcasts
One of the features of the DTR-6.2 that is most frequently used is its
ability to play FM and AM broadcast radio stations. The DTR-6.2
provides a number of listening modes perfect for listening to the
radio and getting the most out of your audio system. Also, by
presetting radio stations that you listen to frequently, you can select
them easily by pressing the CH
button on the remote controller.
Tuning into a radio station
1. Press either the AM or FM input
source button.
2. Using the Tuning and buttons
on the front panel, tune into the
station you desire.
Listening to a stereo radio station (FM mode)
When you tune into a radio station, TUNED
indicator appears in the display. If you tune into
an FM station in stereo, then “FM STEREO”
appears. If the signal is weak, it may be
impossible to tune into the station in stereo. In
such a case, press the FM Mode button on the
front panel. The AUTO indication disappears
and the radio station is output in the monaural
mode. To return to stereo, press the FM Mode
button again. “AUTO” appears. Some inter-
station noise may be heard, but the sound will
not cut in and out as it would if stereo was
selected.
AUTO
TUNED
FM STEREO
Tuned
in stereo
Band Frequency
Auto mode
“FM STEREO”
(Lights red)
• The tuner frequency changes in 50 kHz increments for FM
and 10 kHz increments for AM.
• When tuning into FM stations, you can press the Tuning or
button continuously for more than 0.5 seconds to scan for
an FM station in the direction of the button you pressed (FM
auto tuning mode). After you release the button and a station
is received in stereo, the scanning stops.
FM Mode
AM FM
Tuning
Standby/On
Standby
Power
On O f f
Phones Video 1 Video 3 DVD Video 2 Video 4 Audio Selector Bass Treble
Master Volume
Smart Scan Navigator
Rec Out Zone 2 Zone 2 Level CH Level
Dimmer Display Tuning FM Mode Preset Memory Preset
VCR 1 VCR 2
Tape FM AM Phono CD
Push To Enter
DSP/ Mode ADJ Setup
Return
FM Mode