Infinity Intermezzo 3.5c - Manual (Page 9)

5 INTERMEZZO 3.5c
Amplifier/Receiver
Center-Channel
Speaker Outputs
+ –
BLACK = –
NO STRIPE = – STRIPE = +
RED = +
1. LOOSEN TERMINALS
2. INSERT BARE END;
TIGHTEN TERMINALS
AC CORD
120V – 60HZ 6A
INPUTS POWER
ON
LED
CAUTION!
For continued protection
against risk of fire, replace
only with same type fuse
and rating
ATTENTION!
Utilizer un fusible de
recharge de meme
type et calibre
AC FUSE
3A 250V
OFF ON OFF
TV
NONE SMALL LARGE
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
INTERMEZZO 3.5c
ANSIUL-1492
LR106476
AVIS RISQUE CHOC ELECTRIQUE – NE PAS OUVRIR
+ –
HIGH-PASS
FILTER
TV Size Selector ᕤ
This control optimizes the performance of the Intermezzo 3.5c
based on the size of the TV on which it is placed.
If you are placing the Intermezzo 3.5c behind a perforated
screen for a projection TV, set this switch to “None.”
If you are placing the Intermezzo 3.5c on top of a TV with a
diagonal screen size up to about 36," set this switch to “Small.”
If you are placing the Intermezzo 3.5c on top of a TV with a
diagonal screen size larger than 36," set this switch to “Large.”
High-Pass Filter ᕥ
When set to “On,” this control limits the low frequencies that the
Intermezzo 3.5c will reproduce and allows you to use your
processor’s/receiver’s bass-management settings for an ideal
blend with a subwoofer.
When set to “Off,” the Intermezzo 3.5c will reproduce the entire
frequency range. Use this setting only if your system does not
include a subwoofer.
LED Selector ᕦ
This switch determines whether the green power indicator on
the woofer level control
ᕧ will illuminate when the speaker is
playing. The setting of this switch does not affect the
performance of the speaker in any way.
Setting the Woofer Level Control ᕧ
1. Set the processor’s/receiver’s center-channel-speaker setting
to “Small.”
2. Confirm correct setting of Set TV Size selector
ᕤ.
3. Using the test tones in your receiver/processor, adjust the
center-channel-speaker output (on the processor) to match the
left and right speakers.
4. Finally, fine-tune the level adjustment on the Intermezzo 3.5c
ᕧ to most closely match the tonal balance of the main left and
right speakers. (For the Intermezzo 4.1t, initially set the center-
channel level to “5.”For the Intermezzo 2.6, set to the same
setting as the Intermezzo 2.6’s woofer adjustment.)
Speaker Connections ᕣ