Invacare 636959 - Manual (Page 3)

Part No 636959 3 Aspirator Suction Unit
Grounding Instructions
ƽ WARNING
DO NOT, under any circumstances, cut or remove the round grounding
prong from any plug used with or for Invacare products. Some devices are
equipped with three-prong (grounding) plugs for protection against possible
shock hazards. Where a two-prong wall receptacle is encountered, it is the
personal responsibility and obligation of the customer to contact a qualified
electrician and have the two-prong receptacle replaced with a properly
grounded three-prong wall receptacle in accordance with the National Elec-
trical Code. If you must use an extension cord, use ONLY a three-wire exten-
sion cord having the same or higher electrical rating as the device being
connected.
Operating Instructions
Set-Up
NOTE: For this procedure, refer to FIGURE 1 on page 4.
1. Place unit on a table top or flat work surface.
2. Check that the power switch is Off (O). Refer to Detail “A”.
3. If the unit is cold, let the unit reach room temperature before plugging it in.
4. Connect one end of the connection tubing to the elbow connector on top of the
collection bottle, and connect the other end of the connection tubing to the
hydrophobic filter.
5. Connect the second length of connection tubing between the hydrophobic filter
and the vacuum port barb.
6. Connect the suction tubing to the labeled patient connector (outlet) on the
collection bottle.