Invacare IH6300ADH - Manual (Page 26)

SECTION 5—MAINTENANCE
Supine Bath Tub 26 Part No 1096926
Every Six Months
❑ Verify the water flow temperature with a separate thermometer.
❑ Visually inspect plumbing for leaks.
❑ Check that all labels are present and legible. Replace if necessary.
❑ IH6300ADH ONLY ‐ Re‐apply white lithium grease. Refer to Maintenance for
IH6300ADH Adjustable Height ONLY Glide Pads on page 26.
Maintenance for IH6300ADH Adjustable Height ONLY
Glide Pads
NOTE: For this procedure, refer to
FIGURE 5.1.
NOTE: Glide pads require white lithium grease
applied twice a year.
1. Remove side panel to access glide pads.
2. Generously apply white lithium grease
to stainless steel rub panel.
3. Repeat STEPS 1‐2 for the opposite side.
4. Replace side panels.
FIGURE 5.1 Maintenance for IH6300ADH
Adjustable Height ONLY Glide Pads
Removing Soap Film and Hard Water Deposits
Use a commercially available cleaner such as Invacare’s Heavy Duty Cleaner to thoroughly
spray the exposed surfaces, including the openings of the tub jets and tub suction fitting. Use
a long handled soft brush or similar product to wipe down all surfaces and allow the heavy
duty cleaner to remain in contact with the exposed surfaces for approximately ten minutes.
Rinse off surfaces using the shower wand, adjusted to spray position.
Removing Calcium Deposits, Scale and Lime Build-up
Spray a commercially available cleaner (full strength) for the intended application on all
surfaces to be cleaned. Allow the cleaner to remain in contact with surfaces for at least five
minutes to as long as 12 hours. Rinse off surfaces using the shower wand, adjusted to the
spray position. Use the cleaner according to the manufacturer’s instructions.
Rub Panel
Glide Pad