Invacare IH6300ADH - Manual (Page 14)

SECTION 3—OPERATION
Supine Bath Tub 14 Part No 1096926
Operating the Tub
ƽ WARNING
DO NOT stand in tub. Tub surfaces are slippery when wet. Serious injury may
occur.
DO NOT stand on tub frame. Frame is slippery when wet.
BEFORE immersing the resident or operating the shower/massage wand, check
that the water temperature is between 95° F and 105° F (35° C and 41° C) to avoid
scalding the resident.
Disinfect the tub after EACH use to avoid resident contamination.
NOTE: For this procedure, refer to FIGURE 3.2.
Using Water Temperature Setting
Flow Water Thermometer ‐ Measures the temperature of water coming from the tub fill
spout or shower/massage wand.
Water Temperature Control Valve ‐ Sets and maintains constant temperature for all
incoming water.
ƽ WARNING
ALWAYS hand test the incoming water temperature and the water temperature in
the tub BEFORE immersing the resident. Failure to do so may result in a scalding
injury.
FIGURE 3.2 Using Water Temperature Setting
Whirlpool
Aerator
Flow Water
Thermometer
Shower
ON/OFF Tub Fill
ON/OFF
Flow Water
Thermometer
Shower
ON/OFF
Tub Fill
ON/OFF
Water Temperature
Control Valve
Whirlpool
On/Off
Tub
Control
Down
Tub
Control
Up
Model IH6300 Model IH6300ADH
Whirlpool
On/Off