beautypg.com

Connecting your monitor, Switching on your monitor – IBM 9511-A User Manual

Page 7

background image

5

DEUTSCH

ENGLISH

FRAN

Ç

AIS

ESP

A

Ñ

OL

IT

ALIANO

JAP

A

NESE

COMPL & W

A

RR

Connecting your Monitor

Be sure to read the ‘Safety
Information’
at the front of
this User Guide before
carrying out this procedure.

1.

Turn off your PC and all attached devices.

2.

Connect the signal cable to the video port on the back of your computer.
This port might be directly attached to your computer (figure A), or it
might be part of a video adapter card (figure B). The video port on your
computer or video adapter card may be colored blue to match the blue
connector on your monitor’s video cable.

The AC adapter and signal
cable are connected to

your monitor. If you wish to
change these or to fit a different
stand, see Further Help on
page 22.

3.

Connect the power cord to the power adapter first, then insert the plug
into a properly grounded electrical outlet.

Switching on your Monitor

1.

Switch on the power source and your computer.

2.

Switch on your monitor by pushing and releasing the power switch
marked .
To switch off your monitor, push and release the power switch again.

3.

Turn on the monitor and then the computer.

4.

Run

A

UTO

S

ETUP

by following the instructions in the

Configuring your

Monitor section on page 6.

T54A-E.book Page 5 Saturday, February 19, 2000 12:05 PM

This manual is related to the following products: