IBM T541A - Manual (Page 8)

6
DE
UTSCH
EN
GLIS
H
FRAN
ÇAIS
ESP
AÑOL
IT
A
L
IANO
JAP
A
NESE
COMPL &
W
ARR
Connecting your Monitor
Be sure to read the Monitor
Safety and Warranty manual
that comes with your monitor
before carrying out this
procedure. 1. Turn off your computer and all attached devices.
2. Connect the signal cable to the video port on the back of your computer.
This port might be directly attached to your computer (figure A), or it
might be part of a video adapter card (figure B). The video port on your
computer or video adapter card may be colored blue to match the blue
connector on your monitor’s video cable.
The ac adapter and signal
cable are connected to
your monitor. If you wish to
change these or to fit a different
stand, see the Further help
section (page 19).
3. Connect the power cord to the power adapter and then plug the power
cord into a properly grounded outlet.
Switching on your Monitor
1. Switch on the power source and your computer.
2. Switch on your monitor by pushing and releasing the power switch
marked .
To switch off your monitor, push and release the power switch again.
3. Turn on the monitor and then the computer.