Arm assembly – Image 8.0 User Manual
Page 9
9
48
62
50
48
33
9
11. Secure the Press Top Frame (9) to the Butterfly Top
Frame (33) with two 3/8” x 3 1/4” Bolts (62), two
3/8” Flat Washers (48), and two 3/8” Nylon
Locknuts (50).
Do not tighten the Nylon Locknuts
yet.
12. Secure the Weight Guides (15) to the Press Top
Frame (9) with two 3/8” x 1 3/4” Bolts (57) and two
3/8” Nylon Locknuts (50).
Tighten the Nylon Locknuts used in steps 2–12.
11
12
57
9
50
50
15
13
85
Lubricate
31
33
38
35
Axle
31
38
13.
Locate and open the parts bag labeled “ARM
ASSEMBLY.”
Press a 1 1/2” Square Inner Cap (35) into the back
of the Right Pivot Arm (85). Lubricate the axles on
the Butterfly Top Frame (33). Secure the Right Pivot
Arm to the right axle with two Retainer Rings (31)
and a 1” Round Outer Cap (38).
Do not confuse
the Right Pivot Arm with the Left Pivot Arm (not
shown).
Note: Be sure the Retainer Rings (31) and 1”
Round Outer Cap (38) are oriented as shown in
the inset drawing. The Retainer Rings may
break if disassembled.
Repeat this step with the Left Pivot Arm (not shown)
and left axle.
ARM ASSEMBLY