IOGear GBS301 User Manual

Page 21

Text mode
Original mode

Method 2 – Back to Back Pairing
Follow this procedure to pair two (2) Bluetooth Serial Adapters.

Set one serial adapter to Master (switch 4 = ON), and the other to Slave (switch 4 = OFF)

Upon successful connection, the blue LED on both adapters will turn off and remain off

Finished

Note: Once you have paired both Bluetooth serial adapters, if you turn them off, please allow approximately sixty
(60) seconds when turning them back on to re-establish a connection.

Turn OFF

Set device mode

Make sure both Serial adapters are TURNED OFF

Make sure to set matching Baud rates on both serial adapters; else they will not be able to
communicate. See table 1 on page 9 for additional details.

Set baud rate

Basic Configuration