Setting tag channels, Starting a scan – Icom IC-M90 User Manual
Page 19
13
5
SCAN OPERATION
5
■ Setting tag channels
For more efficient scanning, add desired channels as tag
channels or clear the tag for unwanted channels.
Non-tag channels will be skipped during scanning.
q Select the desired channel to set as a tag channel.
w Push both [Y] and [Z] for 1 sec. to set the displayed chan-
nel as a tag channel.
• “
” appears in the function display.
e To cancel the tag channel setting, push both [Y] and [Z]
for 1 sec.
• “
” disappears.
✔ Clearing all tag channels in the selected channel group
While pushing and holding both [Y] and [Z], turn power ON
to clear all tag channels in the channel group.
■ Starting a scan
Set the weather alert function, priority scan function, scan re-
sume timer and auto scan function in advance, using the SET
mode. (pgs. 17, 18)
q Select the desired channel group (USA, CAN, INT) by
pushing
[CH/WX•
U/I/C/L
] for 1 sec.
, if desired.
• When the weather alert function is in use, select the desired
weather channel with [CH/WX•
U/I/C/L
] and [Y]/[Z].
w Push
[SCAN•
DUAL
]
to start priority or normal scan.
• “SCAN” blinks in the function display.
• “16” appears on the sub channel readout during priority scan.
• When a signal is received, scan pauses until the signal disap-
pears or resumes after pausing 5 sec. according to scan resume
timer setting. (Channel 16 is still monitored during priority scan.)
• Push [Y]/[Z] to check the scanning tag channels, change the
scanning direction or resume the scan manually.
e To stop the scan, push
[SCAN•
DUAL
]
.
• “SCAN” disappears.
• Pushing [PTT], [16•
9
] or [CH/WX•
U/I/C/L
] also stops the scan.
[Example]: Starting a normal scan.
Scan starts.
Push
to stop the scan
Receiving a signal
and audio is emitted.
for 1 sec.
Push