Ironman Fitness Crossover - Manual (Page 9)

Leveling Your Crossover
The Ironman Crossover can be leveled to compensate for uneven surfaces. To level the bike,
raise or lower the four leveling feet (SPS18) located on the underside of the front and rear sta-
bilizers by screwing them in or out as needed.
Maintenance
1. After every use of your Ironman Crossover, use a damp cloth to wipe your unit free from
sweat. You can use soap and water, or a diluted non-abrasive cleaner. Remove residue and
then dry.
2. Inspect the brake pad for excessive wear and replace the pad if necessary. Your unit should
have come with 1 replacement brake pad. If you need additional pads, please contact Ironman
Customer Service at 1-800-750-4766 for replacement brake pads.
3. Inspect the drive belt for correct alignment, tension, or excessive wear. If you experience
any slipping while pedaling, it is possible there is not enough tension on the belt. You will need
to remove the plastic cover (SPS16) to inspect the belt. This is done by removing the 4 screws
(SPJ17) that secure the cover to the frame.
Maintenance and Moving
To move the bike, start by carefully pushing down on the front handlebars until the rear end
of the bike lifts in the air. Steer the bike to another location. Do not attempt to move the unit
over an uneven or rough surface. Be gentle while moving the unit as any sharp impact can
affect the operation.
Moving Instructions
9
Leveler Feed
2 Per Side