Miller Electric 250 - Manual (Page 26)

.
A complete Parts List is available at www.MillerWelds.com
OM-217 455 Page 22
6-3. Typical Stick Welding Connections And Control Settings
Ref. 804 249-A / Ref 228 647-A
! Stop engine.
.
This section provides general
guidelines and may not suit all
applications.
Typical Settings For 7018 (1/8 in)
Electrode:
>
Set Weld Process Selector
switch to + Stick position.
>
Set Coarse Range switch to
60-140 (1/8”) position.
>
Set Fine control at 7 or higher
for best results.
.
Consult the amperage selection
tables below if welding with other
electrodes.
1 Work Clamp
2 Electrode Holder
Connect Work cable to Work terminal
and Electrode holder cable to Elec-
trode terminal on welding generator.
1
2
Tools Needed:
3/4 in