Miller Electric Auto-Axcess 450 - Manual (Page 46)

OM-210 540 Page 42
1 Automation Interface Module PC9
Diagnostic LED’s are visible inside unit,
located on PC9 mounted on left side.
Refer to Section 7-9 for information on
diagnostic LED’s.
Reinstall cover after checking diagnostic
LED’s.
2 Dip Switch S4
Dip switches are used to identify each
circuit board on the internal network. Dip
switch settings are different for each circuit
board. For proper operation, do not change
dip settings from those shown.
216 958-A / Ref. 803 250-C
7-10. Automation Interface Module PC9 Diagnostic LED’s
2
LED32
LED33
LED30
LED31
1
LED1
LED20
LED15
LED2
LED3
LED4
LED5
LED6
LED7
LED8
LED9
LED10
LED11
LED12
LED13
LED14
LED19 LED18
LED17
LED16 LED21 LED22 LED23 LED24 LED26 LED29
LED25
LED27
LED28