Maytag MAH7550AGW - Manual (Page 17)

16
• Use highest spin speed safe for fabric type.
• Load is too small. Very small loads (one or two items) may not spin out completely.
• Make sure door is firmly closed.
• Make sure hose connections are tight.
• Make sure end of drain hose is correctly inserted and secured to drain facility.
• Avoid overloading.
• Too much detergent was used in the pre-wash compartment. Do not exceed 200ml of detergent.
• Check fuse or reset electricity supply.
• Straighten drain hoses. Eliminate kinked hoses. If there is a drain restriction, call for service.
• Close the door and push the Start/Pause touchpad. For your safety, washer will not tumble or spin
unless the door is closed.
• After pressing the Start/Pause touchpad, it will take 30 seconds before the clothes washer begins to
spin. The door must lock before spin can be achieved.
• Plug cord into live electrical outlet.
• Check adapter and power cord connection in cord lock. Remove cord lock to check.
• Check fuse or reset electricity supply.
• Close door and push the Start/Pause touchpad to start the clothes washer. For your safety, washer
will not tumble or spin unless door is closed.
• There may be a pause or soak period in the cycle. Check display to confirm.
• Check screens on inlet hoses at the water taps for obstructions. Clean screens periodically.
• Run the clothes washer through another complete cycle using cold water.
• Reduce detergent amount for that specific load size, soil level and water hardness.
• Turn both water taps on fully.
• Make sure temperature selection is correct.
• Make sure hoses are connected to correct taps and inlet connections. Flush water supply before filling washer.
• Check your hot water supply heater. It should be set to deliver a hot water between 49° C (120° F)
and 60° C (140° F) at the tap. Also check water heater capacity and recovery rate.
• Disconnect hoses and clean filters. Hose and valve filters may be blocked.
• All rinses will be cold.
• While the washer is filling for cold or warm wash temperatures, both hot and cold water will go
through the dispenser as the automatic temperature control feature checks incoming water
temperatures.
• Be sure the door is tightly closed.
• Plug cord into a live electrical outlet.
• Check fuse or reset electricity supply.
• Open and close the door, then push the Start/Pause touchpad.
• Turn both water taps on fully.
• Straighten inlet hoses.
• Disconnect hoses and clean filters. Hose and valve filters may be blocked.
S
ERVICE AND
T
ROUBLESHOOTING
Fills with the
Wrong
Temperature
Water
Tub is Completely
Full of Suds
Stops
Won’t Spin
or Drain
Leaks Water
Load is Too Wet at
End of Programme
C
ONTINUED
C
HECK THESE POINTS IF YOUR
M
AYTAG
N
EPTUNE ® WASHER
...
T
ROUBLESHOOTING
Won’t Fill