Metrologic Instruments MS2421 - Manual (Page 31)

27
S CANNER O PERATION
W AKE A CTIVATION A REA (P HOTOCELL LED O UTPUT )
The MS2421/MS2422 scanner’s default power save mode † is Dual Action Power Save Mode #2 (see page 34). This power
save mode † turns the laser OFF after a configured period of non-use then turns the motor OFF after thirty-minute intervals.
Any movement detected by the photocell in the activation area, shown below in grey, will cause the scanner to exit the power
save mode. The motor will restart automatically and the laser will turn back on preparing the scanner for bar code recognition,
decoding and transmission.
Figure 29. Wake Activation Area Perpendicular to Package Flow Default Range
(Photocell LED Output)
†
Refer to the MetroSelect Configuration Guide (00-02407) for additional information on configurable power save modes.
Specifications are subject to change without notice
.