Checking the package contents, Required tools and consumables, Safe and correct soldering – Motorola FD-1 User Manual
Page 9
FD-1
English
Page 23
!
Checking the package contents
Check the contents of the package for completeness:
§
1 module
§
1 manual
Required tools and consumables
Make sure you have the following tools, equipment and materials ready
for use:
§
a heat-resistant mat
§
a soldering iron stand with tip-cleaning sponge
§
a small side cutter and wire stripper
§
an electronic soldering iron (max. 30 Watt) with a fine tip
§
tin solder (0,5 mm. diameter)
§
wire (diameter: > 0,05 mm² for all connections)
Safe and correct soldering
Caution:
Incorrect soldering can cause fires (through excessive heat). Avoid this
danger by reading the chapter Safety instructions again and
following the directions given.
If you have had training in soldering you can skip this chapter.
§
When soldering electronic circuits never use soldering-water or
soldering grease. They contain acids that can corrode components
and copper tracks.
§
Only use tin solder SN 60 Pb (i.e. 60 % tin, 40 % lead) with rosin-
based flux.
§
Use a small soldering iron with max. 30 Watt. Keep the soldering tip
clean so the heat of the soldering iron is applied to the solder point
effectively.