Morphy Richards VC73215 - Manual (Page 5)

55
Hardfloor nozzle
(certain models only)
Attach the hardfloor nozzle Û
to either the 2 separate
attachable tubes, or the single
telescopic tube (dependant on
model).
This nozzle is ideal for use on
wood, laminate, tile and vinyl
flooring.
USE
1 Assemble the cleaner as
required.
2 While holding the cleaner, use
the plug to pull out the full
length of cable. A red mark
indicates the maximum length.
Do not try to pull the cable past
this mark.
3 Connect the plug to the mains
supply.
4 Press the ON/OFF button fi.
5 Check the suction control and
floor nozzle controls are set as
required.
6 Start vacuuming.
Do not use the cleaner in
an upright position.
AFTER USE
1 Switch off the vacuum cleaner.
2 Unplug from the mains.
3 Rewind the cable by pressing
the rewind button ‹.
WARNING: When using the
cable rewind, always hold
the plug, as the cable will
rewind quickly.
EMPTYING THE
DUST CANISTER
WARNING: Never operate
the cleaner without the
dust canister filter
assembly Ï or motor
protection filter  fitted.
1 Disconnect the cleaner from the
mains socket.
2 Disconnect the hose from the
cleaner.
3 Remove the dust canister ‡
from the cleaner by pushing the
release latch ⁄ C.
4 Take the dust canister to the
bin.
5 By using the click-to-clean
feature Ú, rotate the
pleated filter inside the
mesh filter to shake loose
the dust D.
6 Raise the filter assembly Ï
handle then lift out the filter
assembly from the dust canister
‡ E .
7 Empty the dust canister into the
bin.
8 Place the dust canister safely to
one side.
9 Clean the filters as described
overleaf.
10 Reassemble.
C
E
D
FFoorr ddeettaaiillss ooff ootthheerr M Moorrpphhyy RRiicchhaarrddss pprroodduuccttss,, pplleeaassee sseeee oouurr w weebbssiittee::
73215 rev3 30/9/08 13:33 Page 5