Morphy Richards Essentials Bag Vacuum Cleaner - Manual (Page 5)

55
6 Switch on/off.
• IMPORTANT: Always fix the
hose clip
È to the main
body slot Ë when using the
hose and tools.
• Never over extend the hose
such that the cleaner is
pulled over.
• Turning the cleaner
sideways helps prevent the
cleaner being pulled along
by the stretch hose.
Turbo brush
(certain models only) Ú
This nozzle is suitable for
cleaning and rejuvenating cut
pile stair carpets and upholstery.
It is ideal for picking up
stubborn dirt and pet hairs.
Cleaning the turbo
nozzle
(certain models only)
The turbo nozzle should be
regularly cleaned and any hairs
or fibres wrapped around the
brush bar removed to maintain
optimum performance.
DUST CANISTER
Dust bag indicator
When the cleaner is switched
on, if the dust bag condition
indicator is continuously
showing red (or if the suction is
reduced) the bag must be
replaced and the filters cleaned.
If it is still showing red after
emptying the dust bag and
cleaning the filters, check to see
if the hose is blocked.
Changing the dust
bag
C
1 Unplug the power cable from
the socket.
2 Remove the front by pressing
the release lever at the top.
3 Remove the old dustbag by
holding the cardboard tab and
pull towards you. Remove
carefully to avoid dust/dirt
spilling from the dust bag and
dispose.
4 Take a new dust bag and fold
over the top tab at the crease.
Holding the cardboard tab, push
the bag over the opening of the
dirt discharge tube until it is
seated against the rear of the
enclosure.
5 IMPORTANT: The front panel will
not close unless the dust bag is
correctly fitted due to the safety
bag interlock. The interlock
prevents the cover closing
unless a bag is fitted.
6 Once the new dust bag is in
place, replace the front panel by
aligning the bottom locking tabs
with the slots in the body, close
cover slowly allowing the front
panel to snap in place. The latch
will self lock.
Cleaning the pre-
motor filter
D
Everytime a new bag is fitted,
the filter should be taken out
and cleaned. Failure to clean the
filter will reduce suction and will
damage the motor if used for
prolonged periods. This may
invalidate the guarantee. If the
filter becomes damaged it must
be replaced.
IMPORTANT: Do not operate the
cleaner without the filter in
place.
1 Remove the front cover of the
cleaner. The pre-motor filter is
located below the bag.
2 To remove the filter, slide the
holder out of the machine.
3 Remove the filter from the
holder by unclipping. To clean
shake vigorously over a dustbin.
• The pre-motor filter may also be
washed in warm water.
• Do not use detergents. The filter
must be completely dry before
refitting. Allow the filter to dry
naturally, do not overheat.
5 Replace front cover.
C
D
Í
73342 rev1 13/3/07 15:02 Page 5