beautypg.com

Important, Before using your mr. coffee – Mr. Coffee SRX20 User Manual

Page 7

background image

TO AUTOMATICALLY BREW AT PRE-SET TIME...

1. Follow steps #1 through #5in “How to Brew Coffee”.

2. Always slide the control switch to OFF and then to AUTO.

3. Brewing will begin at the time you have preset and the coffee

will remain hot in the decanter for 2 hours. If more keep warm
time is needed, turn the switch to ON for an additional 2 hour
keep warm time.

IMPORTANT

To Reset Auto Brew at Pre-Set Time.....

This coffeemaker will NOT automatically come on again the

next day if you leave the switch in the AUTO position after
its last use. This is a safety feature. Each time you choose to
use auto brew you must slide the switch to OFF and then to

AUTO.

To make sure Auto brew is set, check the auto off light. If the

light is off, auto brew is set. If it is on, slide the switch to OFF

and then to AUTO.

Before Using Your Mr. Coffee

Make sure your first cup of coffee is as good as can be by cleaning

your Mr. Coffee coffeemaker before you use it the first time. Just

follow these simple steps:

_

1. Wash the .decanter, lid and brew funnel in a mixture of mild

detergent and water. Rinse each thoroughly.

2. Set the clock. The clock on this model must be set first, before

the coffeemaker will operate. See instructions for setting the
clock.

3. Slide the brew funnel into place and then follow steps #4 through

#6 in the “HOW TO BREW COFFEE” section. This will clean
the inside of your coffeemaker.

4. When the brew cycle is finished, slide the control switch to

off. Discard the water in the decanter and rinse the decanter
and brew funnel.

Your coffeemaker is now ready to use.